Skip to content
- You can engrave 3 lines on the front and 3 lines on the back.
- Markings are centered on the jewel: if you fill "line 1" only, the engraving will be on the middle.
- You can add one symbol per line, by writing the corresponding code in the photo below (ex: XLUNE for a moon)
- For each line: only 1 information of 11 characters maximum
- Markings measure 4 mm wide by 1 mm high.
- Any unmarked jewelry ordered cannot be engraved later.
- The marking technique used is laser engraving. No ink is deposited on the bottom of the marking.
